EMAX Skyline32 Naze32 Acro V2 Flight Controller with Compass Support OSD OLED Spektrum Cleanflight Baseflight
Brand Name: EMAX
Item Name: Fligth Controller
Item NO.: Acro V2
32-bit ARM micro processor running at 3.3V / 72MHZ.
With gyro, compass, extended reservation position for accelerometer, barometer.
Manual mode, Angle mode, Horizon mode, heading hold mode, head-free mode
Support Quad-,Tri-,Hex- ,various multirotors.
Flexible RC input: standard, CPPM (PPM SUM)
Battery voltage monitoring and low alarm.
Micro-USB: Flashing firmware & adjusting parameter
Parameters Adjustment Interface: Baseflight-Configuration.
GPS position hold / “Go home” function
Dimension: 35mm x 35 mm x 5 mm (30.5mm Mounting)
Weight: 4.8g (W/O wires)
Different from V1 Version:
Support Spektrum Satellite receiver
Add 3.3V & 5V Soldering Pad at back.
Cleanflight & Baseflight supported. (SKYLINE32 is loaded with Baseflight-Configurator)
Unique wire-to-board connectors, wiring easier!
Thin and light design, reducing overall weight saving mounting space!
With compass sensor, no deviation!
Adapting high quality electronic components & high precision SMT.
Note: SKYLINE32 hardware is compatible with NAZE32 firmware, including cleanflight, baseflight. Below are the links to the source codes:
SKYLINE32 is loaded with baseflight and Baseflight-Configurator GUI. This manual is a baseflight Setup Tuning Guide for SKYLINE32.
If you are using cleanflight firmware, please refer to the below link to download and install cleanflight Configurator:
Note: with firmware and configuration based on “MultiWii” software, the processor used is not Atmel AVR, and can not be compiled via Arduino or other AVR tools.
Below is some information about STM32 development:
1 x Skyline32 Acro Module
2 x Cable